Slider Gift Card Holder
Here are the directions:
Cut a piece of paper 4 ¼” x 5 ½”. Score at 1 3/8” and 4” on the long side. Emboss the piece with Crafts Too CTFD 3032 Polka Dots Folder. Fold on score lines and glue the ends together. Leave both bottom and top ends open. Cut a piece of paper 4 ¼” x 2 3/8”. Punch a slot hole at one end in the middle of that piece. Punch a slot hole in the middle of one end of the pouch piece. Slide the single piece inside the pouch and align the holes. Run a ribbon through those two slots and bring the ribbon up onto each side of the single layer of card. Tie a knot at the top of that card and then a bow. The single layer will slide into the pouch. The gift card is attached to that single card layer. Punch 2 layers of alpine trail punch onto white cardstock and glue them to the front of the holder. Glitter the trees with Stardust Stickles.
SUPER Easy to make!
Please visit these wonderful sponsors if you are considering purchases using products from my gallery:
Bonnie's Best Tools