#6665 on 4/30/12 · Item 27 of 112 on Page 1 of Graduation/School


3D Gift Card Grad Cap



3D Grad Cap Gift Card Holder. The folded card opens to show a gift card inside. See next picture.

To get the smaller cut for the grad cap, start at the bottom edge of the opened (flat) die cut and measure 2 1/2" from the bottom edge all along the entire shape on EACH section. Mark with a pencil as you go and cut along that line to make the cone shorter. Follow the contour of the cone shape to get it correct.

Original idea was from HERE:

Sizzix Big Shot Pro Die

  • 657337 Cone Die
  • Sizzlits Fruit Smoothie Dies (words)
  • Fun Serif (numbers)

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Crop Stop
Customer Loyalty Program and Free Shipping for orders over $50. Don't forget to use "HeartPrints" code at checkout for 10% off!

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.

The Stamp Buzz

Lili of the Valley

Bonnie's Best Tools
Home of the AMAZING Genesis Trimmer
Best Trimmer I have ever owned, by far.