3D Gift Card Grad Cap
3D Grad Cap Gift Card Holder. The folded card opens to show a gift card inside. See next picture.
To get the smaller cut for the grad cap, start at the bottom edge of the opened (flat) die cut and measure 2 1/2" from the bottom edge all along the entire shape on EACH section. Mark with a pencil as you go and cut along that line to make the cone shorter. Follow the contour of the cone shape to get it correct.
Original idea was from HERE:
Sizzix Big Shot Pro Die
Please visit these wonderful sponsors if you are considering purchases using products from my gallery:
Bonnie's Best Tools