#2739 Another version of the Photo Clip.
I printed another picture of Emily for a display item for the LSS and realized that the clip would come up too high and obscure that precious face, so I came up with another idea instead of tossing the photo. I added a larger matte piece (pink) and used 3D tape to stick it to the printed paper leaving space for the "prongs" on the clip to slip up underneath the photo and matte, also stabilizing the clip from tippping over. The first picture clip had a much smaller picture and could accommodate the prongs, but this didn't. Using this solution, I can use larger photos than the first one. I even have enough space on the clip to slide it down further if needed.
Just thought you would like to see another angle. | 
