#3072 on 5/9/08 · Item 14 of 266 on Page 1 of Miscellaneous

#3072

5.5" square card House Mouse: HMGR1013 Twinkle Toes Nestabilities-Panel Embossing Embossed the frame outline of the Nestabilities die doing the following: From the BOTTOM to the TOP using the CUTTLEBUG A PLATE B PLATE TAN MAT cut as large as the cardstock you are using 3 single layers of cardstock same size as the tan mat YOUR CARD STOCK (I used the 130 lb Beckett) Die-cutting side down B PLATE Run thru the Cuttlebug and it will emboss the shapes, and NOT cut thru the cardstock. This works best with the heavier CS and will do this with all of the Nestabilities shapes. Original idea for the embossing came from Paper Trey. Hand Doodling Stickles Magic Colored Pencil Technique a.k.a. Gamsol Magic Alphabeads NOTE: Everything I use can be purchased from Arnies Arts and Crafts, the LSS where I make samples. Email Penny at penny@arnies.com (Greenville location) and give her product numbers and descriptions so it is easy for them and you. Reference card #3072 so they can look it up on my HeartPrints gallery to insure no mistakes in your order. I am going to start posting this info each time, since I get numerous questions after each post. Might be a good idea to send a copy of the card with the email.

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.