#3222 on 9/7/08 · Item 23 of 447 on Page 1 of Candy/Bags/Boxes
popup tail

#3237 This uses an acetate candy bag, but anything will do. I did not use googlie eyes on this because...
popup tail
popup tail

#3236   Bag Instructions to cut the Bat   4" scalloped square.....fold the square...
popup tail
popup tail

#3234 Gummy Mummy   Used a regular pack of gun, 2- 3/8" x 12" strips of textured ivory...
popup tail
popup tail

#3226 Another sour cream acetate candy container   Cuttlebug: Halloween Die  
popup tail
popup tail

#3222 Another Acetate Candy Container 4.25" x 5.5" piece of acetate or transparency. Glue...
popup tail
popup tail

#3221 4.25" x 5.5" piece of acetate or transparency. Glue tape is applied on the 2 long...
popup tail
popup tail

#3220 Sour Cream Candy Container 4.25" x 5.5" piece of paper. Glue tape is applied on the 2...
popup tail
popup tail

#3217 A2 size candy holder. The circle swings away to reveal a candy treat! Cut paper at 4.25" x...
popup tail
popup tail

#3085 Acetate bags from www.clearbags.com Item #FG3 This is the small size 1.5" x 2" and I...
popup tail
Candy/Bags/Boxes · Halloween

#3222

Another Acetate Candy Container

4.25" x 5.5" piece of acetate or transparency.

Glue tape is applied on the 2 long sides and one short side. Roll into a tube and press taped edges together. Pinch the end closed, with the center seam in the middle of the pinched end. Add Candy. Turn the tube a quarter turn and pinch that seam closed, as shown. I had trouble with the tape not sticking so I added a staple to each closure.

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.