#2838 on 2/9/08 · Item 5 of 22 on Page 1 of Cuttlebug Tutorials
popup tail

#2842 Here is the front view of the first 2 steps.
popup tail
popup tail

#2841 Next, position the cuttlebug folder on the front of the folded card so that it aligns to your...
popup tail
popup tail

#2840 Another view of placement.
popup tail
popup tail

#2839 Run the prepared folder and card thru the Cuttlebug and this is the finished view of the...
popup tail
popup tail

#2838 Finished View: Cuttlebug Embossing on SINGLE LAYER of cardstock. Once finished, glue this to a...
popup tail
popup tail

#2837 This is a SINGLE layer sheet for embossing. Position the folder on the top half of the cardstock...
popup tail
popup tail

#2836 Position the folder on the bottom portion of the single layer of cardstock and run it thru the...
popup tail
popup tail

#2834 This is the picture of the embossed areas on top and bottom of the SINGLE layer of cardstock, with...
popup tail
popup tail

#2833 This is the single layer card laid face down on the Scor-Pal after two sets of parallel lines have...
popup tail
Cuttlebug Tutorials

#2838

Finished View: Cuttlebug Embossing on SINGLE LAYER of cardstock. Once finished, glue this to a folded card either with a matte layer underneath, or without. Some trimming may be needed. Step by step follows. Card # 2832 is a finished example. http://www.heartprints.net/gallery/all/card/2832/

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.