#4115 on 3/15/10 · Item 3 of 11 on Page 1 of Ribbon Butterfly Tutorial
popup tail

#4119 While still holding the two upper wings in place, WRAP the brad over the top and bottom of the...
popup tail
popup tail

#4118 This shows the back view.

popup tail
popup tail

#4117 Now take the remaining ribbon tail on the right side and form a smaller loop, tucking it up and...
popup tail
popup tail

#4116 Secure that loop within the prongs of the brad. You can adjust those later. Do the same thing to...
popup tail
popup tail

#4115 View of the back of the butterfly with all 4 loops formed. Adjust the bottom loops now before...
popup tail
popup tail

#4114 The two bottom loops should be smaller than the top loops to create the bottom wings. Adjust them...
popup tail
popup tail

#4113 Finished butterfly. You can add flower "Stamen" to create the antennae. They can be found...
popup tail
Ribbon Butterfly Tutorial

#4115

View of the back of the butterfly with all 4 loops formed. Adjust the bottom loops now before pinching the brad prongs tight and trimming the excess ribbon off.

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.