#4122 on 3/15/10 · Item 10 of 11 on Page 1 of Ribbon Butterfly Tutorial
popup tail

#4123 Start with a 9" piece of ribbon. Fold at the middle point and press to make a crease mark.
popup tail
popup tail

#4122 Make a loop with the right half of the ribbon, at the middle mark. This forms one of the top wings...
popup tail
popup tail

#4121 Make another loop to form the left top wing and hold in place.
popup tail
popup tail

#4120 Open up a brad all the way. This holds the wings in place and forms a decorative body area for the...
popup tail
popup tail

#4119 While still holding the two upper wings in place, WRAP the brad over the top and bottom of the...
popup tail
popup tail

#4118 This shows the back view.

popup tail
Ribbon Butterfly Tutorial

#4122

Make a loop with the right half of the ribbon, at the middle mark. This forms one of the top wings and should be larger than the bottom wings. Hold in place.

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.