#2844 on 2/9/08 · Item 11 of 22 on Page 1 of Cuttlebug Tutorials
popup tail

#3124 Open the folder and cut slowly, following the dot pattern. If you have one with a random pattern,...
popup tail
popup tail

#3123 I then cut the second half of the cut folder in half again.
popup tail
popup tail

#2891 I have been getting a lot of inquiries about the Lasting Impressions Pre-embossed foldover notes,...
popup tail
popup tail

#2845 This is the tutorial for the folded card embossing. Cut the card at 4.25" x 11". Fold in half.
popup tail
popup tail

#2844 Place the small embossing folder where you want it embossed. Run it thru the Cuttlebug. In order to...
popup tail
popup tail

#2843 Score the lines you wish on the Scor-Pal.
popup tail
popup tail

#2842 Here is the front view of the first 2 steps.
popup tail
popup tail

#2841 Next, position the cuttlebug folder on the front of the folded card so that it aligns to your...
popup tail
popup tail

#2840 Another view of placement.
popup tail
Cuttlebug Tutorials

#2844

Place the small embossing folder where you want it embossed. Run it thru the Cuttlebug. In order to avoid the crease mark from the top edge of the folder, when you feel the roller getting close to the edge of the folder, back the roller off and reverse the roller so it comes back out the way it went in. If that does not work, add a layer of thin paper underneath the cardstock and that may eliminate the crease.

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.