#3124 on 6/20/08 · Item 15 of 22 on Page 1 of Cuttlebug TutorialsItem 15 / 22 PreviousNext
popup tail

#3198 here it is with the rubber on top of the folder.
popup tail
popup tail

#3197 3. Because the 1/8" red rubber piece REPLACES the 2nd B Plate in the embossing process, (due to the...
popup tail
popup tail

#3196 Shim the plate recipe with one layer of cardstock if the impression is not deep enough for...
popup tail
popup tail

#3195

popup tail
popup tail

#3124 Open the folder and cut slowly, following the dot pattern. If you have one with a random pattern,...
popup tail
popup tail

#3123 I then cut the second half of the cut folder in half again.
popup tail
popup tail

#2891 I have been getting a lot of inquiries about the Lasting Impressions Pre-embossed foldover notes,...
popup tail
popup tail

#2845 This is the tutorial for the folded card embossing. Cut the card at 4.25" x 11". Fold in half.
popup tail
popup tail

#2844 Place the small embossing folder where you want it embossed. Run it thru the Cuttlebug. In order to...
popup tail
Cuttlebug Tutorials

#3124

Open the folder and cut slowly, following the dot pattern. If you have one with a random pattern, draw a line with a fine point sharpie on the entire folder, and carefully cut