#3197 on 8/19/08 · Item 18 of 22 on Page 1 of Cuttlebug Tutorials
popup tail

#3364 This is how to do the frame embossing You need a red sheet of rubber from Lowes called Rubber...
popup tail
popup tail

#3363 B Plate on top   This is the view of the 2nd B Plate on top of the folder. A cardstock...
popup tail
popup tail

#3199 Okay, here is a way to eliminate the crease lines from the embossing folders. This will work for...
popup tail
popup tail

#3198 here it is with the rubber on top of the folder.
popup tail
popup tail

#3197 3. Because the 1/8" red rubber piece REPLACES the 2nd B Plate in the embossing process, (due to the...
popup tail
popup tail

#3196 Shim the plate recipe with one layer of cardstock if the impression is not deep enough for...
popup tail
popup tail

#3195

popup tail
popup tail

#3124 Open the folder and cut slowly, following the dot pattern. If you have one with a random pattern,...
popup tail
popup tail

#3123 I then cut the second half of the cut folder in half again.
popup tail
Cuttlebug Tutorials

#3197

3. Because the 1/8" red rubber piece REPLACES the 2nd B Plate in the embossing process, (due to the width restrictions when rolling the plate through the machine), you will assemble the plates as follows: A Plate Embossing folder with red rubber attached and paper inside B plate (only one) Run it through the Cuttlebug and voila! No crease!

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.