#3196 on 8/19/08 · Item 17 of 22 on Page 1 of Cuttlebug Tutorials
popup tail

#3363 B Plate on top   This is the view of the 2nd B Plate on top of the folder. A cardstock...
popup tail
popup tail

#3199 Okay, here is a way to eliminate the crease lines from the embossing folders. This will work for...
popup tail
popup tail

#3198 here it is with the rubber on top of the folder.
popup tail
popup tail

#3197 3. Because the 1/8" red rubber piece REPLACES the 2nd B Plate in the embossing process, (due to the...
popup tail
popup tail

#3196 Shim the plate recipe with one layer of cardstock if the impression is not deep enough for...
popup tail
popup tail

#3195

popup tail
popup tail

#3124 Open the folder and cut slowly, following the dot pattern. If you have one with a random pattern,...
popup tail
popup tail

#3123 I then cut the second half of the cut folder in half again.
popup tail
popup tail

#2891 I have been getting a lot of inquiries about the Lasting Impressions Pre-embossed foldover notes,...
popup tail
Cuttlebug Tutorials

#3196

Shim the plate recipe with one layer of cardstock if the impression is not deep enough for you. Cut one red sheet for each size of embossing folder and just change them up with each folder. This original idea of the "plate" revision came from StampinJay on Gingerwood. She used craft sticks. I then tried cutting a spare B Plate and that worked well, but Mrs C. on GW came up with the idea of the 1/8" thick red rubber. It works better and is do-able for everyone.

Please visit these wonderful sponsors if you are considering purchases using products from my gallery:

Marco's Paper
Check out their huge selection of paper, envelopes and stamping supplies.